Lan Remote Control - Mitsubishi LDT551V User Manual

Panel tv

Table of Contents

U-12

Remote control (continued)

5) Read command

The computer sends the command without datacode to the monitor.

After receiving this command, the monitor returns the command with datacode including the current status to the computer.

Example: When the computer asks the power status of the monitor, and the status of the monitor is powered-on.

Command from computer

30 30 76 50 0D '0''0''v''P'[enter]

Structure of the Read-command

POWER

OFF (Sleep)

RGB-1 (HDMI)

RGB-2 (DVI-D)

RGB-3 (D-SUB)

RGB-4 (BNC)

Input

OPTION*

RGB-6 (DISPLAY PORT)

Video

DVD/HD

S-VIDEO

Around the main

Internal

board

temperature

Around the power

supply

OPTION can be used when an optional module is mounted on the option slot.

By connecting the monitor and the computer using a network device such as a LAN hub as shown in Section P-7 and making

the network settings using the OSD menu and RS-232C communication control, you can perform remote control using the same

commands as those for RS-232C.

1. Setting procedure

(1) Set the following network parameters using the OSD menu. (See page 48.)

• DHCP client ON/OFF, IP address, subnet mask and default gateway

(2) Set the IP address described above and the port number (63007 or 3007) using the application program of your computer to

perform the socket communication.

(3) Send the same control command as that for RS-232C via TCP/IP socket communication.

(4) Check the status sent from the monitor. When it is received successfully, the setting is completed.

Command from monitor

30 30 76 50 31 0D '0''0''v''P''1'[enter]

ASCII

Function

Resolution

tc1

1˚C

Resolution

tc2

1˚C