Panasonic TH-37PR10R Operating Instructions Manual page 13

The remote control is not included with this set. Available for purchase separately.
Object model : EUR7636090R
Standby (ON / OFF) button
The Plasma Display must fi rst be plugged into the wall outlet and turned on at the power switch (see page 11).
Press ON to turn the Plasma Display On, from Standby mode. Press OFF to turn the Plasma Display Off to Standby
mode.
ACTION button
Press to make
POSITION
selections.
buttons
SOUND button
(see page 24)
R button (see page 15)
Press the R button to return to previous menu screen.
Status button
Press the "Status" button to display the current system status.
PC
4 :3
Off timer 90
SET UP button (see page 14, 15)
DIRECT INPUT buttons
Press the INPUT "1", "2", "3" or "PC" input mode selection button to
select the input mode.
This button is used to switch directly to INPUT mode.
These buttons can only display the slot which is installed. If you
press the button whose slot is not installed, it automatically displays
the current input signal.
When a dual input terminal board is attached, A or B is displayed
depending on the selected input signal. (Ex. INPUT1A, INPUT1B)
Note:
Image retention (image lag) may occur on the plasma display panel
when a still picture is kept on the panel for an extended period. The
function that darkens the screen slightly is activated to prevent image
retention (see page 45), this function is not the perfect solution to
image retention.
Channel Adjustment
You can use this button when U/V Tuner Board with Hospitality Port
is installed (optional accessories). Refer to each Board's Operating
Instruction for detail.
Volume Adjustment
Press the Volume Up "+" or Down "–" button to increase or decrease
the sound volume level.
OFF TIMER button
The Plasma Display can be preset to switch to stand-by after a
fi xed period. The setting changes to 30 minutes, 60 minutes, 90
minutes and 0 minutes (off timer cancelled) each time the button
is pressed.
30
When three minutes remain, "Off timer 3" will fl ash.
The off timer is cancelled if a power interruption occurs.
Digital Zoom (see page 25)
Press to access
Digital Zoom.
This displays an enlargement of the designated part of the
displayed image.
Basic Controls
Input label
1
1
Aspect mode (see page 17)
2 2
Off timer
3
The off timer indicator is
displayed only when the off
3
timer has been set.
60 90
0
13