Baby Monitor (Additional Handset Required); Call Options - Panasonic KX-TCD820FX Operating Instructions Manual

TCD820FX(e-e).book Page 34 Tuesday, September 13, 2005 9:10 AM
Handset Settings
m
1
" (centre of joystick) i m i #
2
"Display Setup" i #
3
"Contrast" i #
4
Push the joystick up or down to select
the desired contrast. i # i
{ih}
Baby monitor (additional
handset required)
Using the baby monitor
This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
the house. The monitored handset (placed
in a baby's room, for example) will
automatically call the monitoring handset
when it detects sound.
Perform the following procedure with the
handset that will be monitored (for example,
the handset placed in the baby's room).
1
" (centre of joystick) i m i #
2
"Baby Monitor" i #
3
"On/Off" i #
4
"On" i #
5
Select the desired handset number. i
#
L "Baby Monitor" will be displayed.
Note:
L The monitoring handset will answer calls
automatically when the auto intercom
feature is set to "On" (page 35).
L The handset cannot be used while it is
waiting to monitor. To cancel monitoring;
" i "Off" i # i {ih}
Baby monitor sensitivity
You can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity
34
to adjust the sound level needed to trigger
the baby monitor feature.
1
" (centre of joystick) i m i #
2
"Baby Monitor" i #
3
"Sensitivity" i #
4
Select the desired setting. i # i
{ih}

Call options

Storing the direct call number
This feature prohibits making outside calls
except to the phone number you store here.
The number will be dialled automatically
when {C} or {s} is pressed.
1
" (centre of joystick) i m i #
2
"Call Options" i #
3
"Direct Call" i #
4
"Phone Number" i #
5
Enter the phone number (24 digits
max.). i #
6
"Save" i #
7
"On" i # i {ih}
L p is displayed.
Turning direct call on/off
1
" (centre of joystick) i m i #
2
"Call Options" i #
3
"Direct Call" i #
4
"On/Off" i #
5
Select the desired setting. i # i
{ih}
Turning auto talk on
When this feature is turned on, you can
answer calls simply by lifting the handset off
the base unit. You do not need to press
{C}.