Panasonic WV-PS154 Operating Instructions Manual page 10

1. Connect a coaxial cable from a camera to a CAMERA
IN connector of the camera drive unit. Maximum cable
lengths are approximately as shown below.
Coaxial DC R/300 m (1000 ft.) of
Cable Type Inner Conductor
RG-59/U Less than 30
RG-6/U Less than 12
The maximum DC resistance of the cable between the
camera and camera drive unit is 20 .
2. Connect a coaxial cable from a video monitor to the
VIDEO OUT connector of the camera drive unit.
Maximum cable lengths are approximately as shown
below.
Type of
coaxial cable
Recommended
Maximum
cable length
Note:
If the length of the coaxial cable between the cam-
era drive unit and the video monitor exceeds the
distance shown in the above table, a cable loss
compensator should be used between the camera
drive unit and the video monitor.
3. After connecting the specified camera to the camera
drive unit, connect the audio cable between the monitor
and AUDIO OUT connector of the camera drive unit.
10
Maximum
Cable Length
200 m (660 ft.)
500 m (1 650 ft.)
RG-59/U RG-6/U
(3C-2V) (5C-2V)
(m) 250 500
(ft) 825 1 650
External VD/SYNC Signal
Signal Level
The VD/SYNC IN connector receives the VD or VS synchro-
nizing signal for external synchronization.
• VD: 4 V[p-p]/75
• Composite Sync: 4 V[p-p]/75
RG-11/U
(7C-2V)
600
1 980
• VS: 1 V[p-p]/75
Accuracy of vertical signal
Vertical frequency: 50 Hz ± 0.0013 Hz
Relation between VD/SYNC IN and VD/SYNC OUT
The signals from the VD/SYNC OUT connector differ
depending on the connected camera and the signals
received at the VD/SYNC IN connector of the camera drive
unit.
The signals supplied from VD/SYNC OUT are as follows:
Connected
Camera
WV-BP50E
WV-CP110E
Signal to
VD/SYNC
IN No signal VD signal
Composite
or VD signal
signal
Composite
signal
Composite
signal