Panasonic WV-PS15 Operating Instructions Manual page 7

1. Connect a coaxial cable from a camera to a
CAMERA IN connector of the camera drive
unit. Maximum cable lengths are approxi-
mately as shown below.
Coaxial DC R/300m
Cable Type (1 000 ft.) of
Inner Conductor
RG-59/U Less than 30
RG-6/U Less than 12
The maximum DC resistance of the cable
between the camera and camera drive unit is
20 .
2. Connect a coaxial cable from a video monitor
to the VIDEO OUT connector of the camera
drive unit. Maximum cable lengths are ap-
proximately as shown below.
Type of
coaxial cable
Recommended
Maximum
cable length
Note:
If the length of the coaxial cable between
the camera drive unit and the video mon-
itor exceeds the distance shown in the
above table, a cable loss compensator
should be used between the camera
drive unit and the video monitor.
3. After connecting the specified camera to the
camera drive unit, connect the audio cable
between the monitor and AUDIO OUT con-
nector of the camera drive unit.
7
Maximum
Cable Length
200 m (660 ft.)
500 m (1 650 ft.)
RG-59/U RG-6/U RG-11/U
(3C-2V) (5C-2V)
(m) 250 500
(ft) 825 1 650
External VD/SYNC Signal
Signal Level
The VD/SYNC IN connector receives the VD or
VS synchronizing signal for external synchroniza-
tion.
• VD: 4 V[p-p]/75
• Composite Sync: 4 V[p-p]/75
• VS: 1 V[p-p]/75
(7C-2V)
600
1 980
Accuracy of vertical signal
Vertical frequency: 50 Hz ± 0.0013 Hz
Relation between VD/SYNC IN and VD/SYNC
OUT
The signals from the VD/SYNC OUT connector
differ depending on the connected camera and
the signals received at the VD/SYNC IN connec-
tor of the camera drive unit.
The signals supplied from VD/SYNC OUT are as
follows:
Connected
Camera
WV-BP50E
WV-CP110E
Signal to
VD/SYNC
IN No signal VD signal
Composite
or VD signal
signal
Composite
signal
Composite
signal