Panasonic WV-BS300 Operating Instruction page 14

(1)-1 ALC Mode with Preset Mode (PRESET ON)
• Move the cursor to "PRESET" and select "ON" by using the joystick. The preset mode menu is displayed on
the monitor screen as shown.
• Move the cursor to "RET" by using the joystick and press the CAM (SET) button to return to the setup menu.
Blinking
B
(1)-2 ALC Mode with Field Setup Mode (PRESET OFF)
• Move the cursor to "PRESET" and select "OFF" by using the joystick.
• The field setup menu is displayed on the monitor screen as shown.
• Move the cursor to "MASK SET" and press the CAM (SET) button. The
48 mask areas appear on the monitor screen. The left top area has a
blinking cursor.
• To mask this area, press the CAM (SET) button. The mask and the
cursor start blinking alternately.
• To mask other areas, move the cursor to the desired area by using
the joystick. Then press the CAM (SET) button to mask that area. The
area turns to white.
• When the cursor is moved to an area that has already been masked,
the mask and cursor start blinking alternately.
• Press the CAM (SET) button if this masking for this area is to be
canceled.
• Press the F2 button of WV-CU550A when all masking areas are to be
canceled.
• After masking is completed, press the CAM (SET) button for more
than 2 seconds. The 48 mask areas on the monitor screen disappear
and the field setup menu is then displayed.
• If the video output level (picture contrast) is to be changed, move the
cursor to "LEVEL" and control the joystick to adjust the iris of the ALC
lens. When the cursor is moved in the right (+) direction, the lens iris
is opened wider, causing the video output level to rise.
If the cursor is moved in the left ( ) direction, the reverse takes place.
• Move the cursor to "RET" by using the joystick and press the CAM
(SET) button to return to the setup menu.
Blinking
- 11 -
Turns to white
Blinking
* ALC CONT *
BACK LIGHT COMP
PRESET
MASK SET *
LEVEL
RET
* ALC CONT *
BACK LIGHT COMP
PRESET
MASK SET *
LEVEL
RET
OFF
....I....
+
OFF
....I....
+