HANNspree HannsBook SN10E2 Series User Manual page 20

Make sure you have these ready:
1. An USB DVD drive.
2. A Netbook driver CD.
3. Windows XP Install CD.
Before we continue :
■ Shut down your computer.
■ Connect the USB DVD drive to an USB port of Netbook and connect the power
cord to AC power.
2-1 Insta�� a ne� �indo�s �P system
1. Press <Del> to enter BIOS setup during POST, select and the go to "Boot" menu,
set " " 1st Boot Device" to USB DVD drive, press <F10> save changes and exit
BIOS.
Main Advanced Security Boot Exit
Boot Settings
Quick Boot
Quiet Boot
Onboard .AN Boot ROM
Boot Device Priority
1st Boot Device
2nd Boot Device
1st Hard Disk Drive
1st CD/DVD Drive
2. Insert the Windows XP Install CD into the USB DVD drive. The computer will reboot, Windows XP Install CD into the USB DVD drive. The computer will reboot,
and it will start installing Windows XP Operating System. The figure is shown as
below:
BIOS SETUP UTI.ITY
Boot
[Enabled]
[Enabled]
[Disabled]
[USB:TEAC DV�W28SS�]
[SATA:PM�WDC WD1���] SATA:PM�WDC WD1���] ]
[SATA:PM�WDC WD1���]
[USB:TEAC DV�W28SS�]
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
into the USB DVD drive. The computer will reboot,
Specifies the boot
sequence from the
available devices .
A device enclosed in
parenthesis has been
disabled in the
corresponding type
menu.
←→ Select Screen
↑↓ Select Item
+- Change Field
F1 General Help
F1� Save and Exit
ESC Exit
16