Panasonic TX-51P100 Operating Instructions Manual page 28

Tuning Procedure
5
If the sound is not clear or no
sound is produced on a
+
Programme Number Position,
push the Volume Up "+" or
Down " " button.
Push the "PRE." (PRESET)
6
button 4 times.
PRE.
Helpful Hint
(1) If a clear picture cannot be obtained even when a Broadcast or AV signal is received, refer to the "Colour System
Selection" operation on page 35.
(2) After the Manual tune is finished, push the Programme Number " " button to confirm the tuning condition for each
Programme Numbers. If some Programme Numbers are unused, it is possible to skip such Programme Numbers.
Please refer to the Programme Number skip operation on page 30.
(3) When using a VCR without video and audio input/output terminals, it is convenient to connect the aerial cable as
indicated in the instruction manual of VCR and to set the designated channel to programme No."0". In that case,
perform manual tune after setting the colour system and sound system in advance. Further, in multi-system VCR,
it is more convenient to set the designated channel to several programme Numbers.
2
CH4
Yo u m ay i m p r o ve t h e
Sound quality.
The sound indicator will
change as follows.
4.5MHz 5.5MHz
6.5MHz 6.0MHz
Note:
When sound volume is too
small to confirm, turn it up
by using the sound volume
b u t t o n o n t h e r e m o t e
control.
This returns the set to the
normal viewing condition.
27