Panasonic Viera TX-P50VT20BA Operating Instructions Manual page 112

On screen messages
Message
No channel found.
Please check aerial or local signal
availability.
Press OK to start Auto Setup.
No module inserted
No recording - Already recording
No recording - Check media
No recording - Playing
No recording - Unknown reason
No service
No signal
Overcurrent error on USB device
occurred.
Please remove the USB device, and
switch off the TV by mains power switch.
PIN incorrect!
Please check settings and connections
on HDMI devices.
Please enter a frequency between
10700 and 12750 MHz.
Please wait.
Recording this channel now
Reset to Factory Shipping Condition
Completed.
Please switch off TV.
Sending Preset Data
Software successfully updated.
Press EXIT to continue.
Software update failed. Please try again
later.
Press EXIT to continue.
The device is not directly connected to
the TV.
The device may not work correctly.
This timer will not follow the TV Guide
information.
Press OK to continue, RETURN to restore
original timer.
112
Meaning / Action
●
Follow the on screen instructions.
●
Please also refer to p. 107.
●
If channels are still not found, consult your local Panasonic dealer.
●
Check the CI module is inserted completely (p. 64).
●
The equipment may already be recording.
●
The tape or disc may be "write protected", full, missing or damaged.
●
The equipment may be playing the tape or disc.
●
The recording may not be performed. Check the equipment.
●
The broadcaster has stopped the service. Check the channel in the TV
Guide. (p. 20)
●
The TV cannot detect the signal. Check the connection of the RF cable.
●
The connected USB device might cause overcurrent error. Follow the on
screen instructions.
●
Check if foreign objects are inside the USB port.
●
The PIN number you entered is wrong.
●
Communication error in VIERA Link function (p. 95).
●
The frequency you entered is out of range. Consult the received satelite
broadcasting company. (p. 54)
●
A function is in progress.
●
The recorder is recording the programme from its own tuner. You can turn
the TV off and leave the equipment recording in the normal way.
●
"Auto Setup" will automatically start when Mains power On / Off switch is
next turned On. (p. 12)
●
Q-Link or VIERA Link channel download is in progress.
●
The software updating is finished.
●
Perform "System Update Search Now" in System Update (p. 65).
If this is still unsuccessful, there may not be any new software available.
●
Please do not connect the device via a USB HUB.
●
If you edit the start time or end time of Guide link programming by more
than 10 minutes, it will no longer be performed as Guide link programming.
The programming will be performed according to the time setting.