Panasonic Viera TX-P50VT20BA Operating Instructions Manual page 108

FAQs
Chaotic image, noisy
No image can be displayed
Blurry or distorted image
(no sound or low volume)
Unusual image is displayed
No sound is produced
Sound level is low
or sound is distorted
Unusual sound from the TV
No programmes shown on TV
Guide
Cannot find a channel
you have previously watched
108
Problem
●
Set "P-NR" in the Picture Menu (to remove noise). (p. 38)
●
Check nearby electrical products
(fluorescent lamp, DECT phones, mobile phones, microwave, etc.).
●
Is "Contrast", "Brightness" or "Colour" in the Picture Menu set to the
minimum? (p. 38)
●
Please also refer to "Neither image nor sound is produced" (p. 107).
●
Reset channels. (p. 46 and p. 47)
●
Please also refer to "Neither image nor sound is produced" (p. 107).
●
Turn the TV Off with Mains power On / Off switch, then turn it On
again.
●
If the problem persists, perform "Shipping Condition" (p. 57).
●
Is "Sound mute" active? (p. 8)
●
Is the volume set to the minimum?
●
Is Speaker Selection (VIERA Link) set to "TV"?
●
Please also refer to "Neither image nor sound is produced" (p. 107).
●
Sound signal reception may be deteriorated.
●
Set "NICAM" (p. 39) in the Sound Menu to "Off". (Analogue only)
●
Please also refer to "Neither image nor sound is produced" (p. 107).
●
When power is on, whirring sound of cooling fan or drive noise may
be heard from inside the TV (not a sign of faulty operation).
●
Reset channels. (p. 46 and p. 47)
●
Check the digital transmission by contacting Digital UK on
08456 50 50 50 or at www.digitaluk.co.uk
●
Check the analogue broadcast (if still available in your area).
●
Consult an aerial or dish engineer to check the alignment of your
aerial or dish.
●
The channel may broadcast for part of the day.
●
Check the channel in the TV Guide. (p. 20)
●
Channel position numbers may be changed by broadcasters.
●
Reset channels. (p. 46 and p. 47)
Actions