Front View; Rear View - Panasonic WJ-HD500 Instructions Manual

Appearance

Front View

Rear View

<FRONT VIEW>
q Operate Indicator [OPERATE]
Lights in green while the power is supplied to the
unit. Lights in orange when a thermal error is detect-
ed inside the unit.
w HDD Access Lamps [HDD 1] [HDD 2] [HDD 3]
[HDD 4]
Lights while the HDD is accessed. Do not turn off
the POWER switch while any of the access lamps is
lit.
e Front Lids
Four HDD openings are prepared inside the exten-
sion unit. Remove the lid to install the HDD. Replace
the lid after installation.
<REAR VIEW>
r SCSI In connector [EXT IN]
Connect the WJ-HD500 or other Extension Unit with
a SCSI cable.
t SCSI Out connector [EXT OUT]
Connect another Extension Unit with a SCSI cable.
y SCSI ID Switch [SCSI ID –/+]
Press the upper or lower selector with a small head-
ed screw driver to select the desired SCSI ID in the
chain.
HDD 1
HDD 2
HDD 3
OPERATE
HDD 4
OPERATE LED WILL CHANGE TO ORANGE
IF THE INSEDE TEMPERATURE EXCEEDS OR FALLS BELOW THE LIMIT.
q
w
EXT IN
EXT OUT
SCSI ID
–
TERMINATOR
+ ON
OFF
t
r y u i
e
o
u Termination Switch [TERMINATE ON/OFF]
Set this switch to ON when the extension unit is
located at the end of SCSI chain. Set this to OFF
unless the unit is located at the chain end.
i Terminal Board [THERMAL ERROR OUT] [G]
A thermal error signal is supplied and OPERATE
LED lights in orange when the inside temperature
exceeds or falls below the limit. Connect these ter-
minals with the WJ-HD500.
[NC]: No connection
o Cooling Fan
!0 AC Inlet [AC IN]
Connect the supplied power cord.
!1 Power Switch [POWER]
Turn on this switch (peripherals) first, then the power
of the WJ-HD500.
Confirm all HDD access lamps go out before turning
off this switch. Switch off the power of
HD500 first, then turn off this switch (peripherals).
!2 Signal GND Terminal [SIGNAL GND]
Connect this terminal with other equipment's SIG-
NAL GND to avoid possible grounding loop and
noise if required.
-3-
Extension Unit WJ-HDE
AC IN
POWER
ON
OFF
SIGNAL GND
!0 !1
!2
the WJ-