Alarm Reset; Other Functions; Camera Switching Pulse Loss Display - Panasonic WJ-FS109 Operating Instructions Manual

Alarm Reset

Manual Reset
When an alarm is activated, the ALARM Indicator blinks.
The indicator keeps blinking until all alarms are cleared by
pressing the ALARM RESET button.
The blinking or lit indicator goes off.

OTHER FUNCTIONS

Camera Switching Pulse Loss
Display
• When loss of the camera switching pulse is detected,
"SW LOSS" will blink on the monitor screen.
• The buzzer does not beep.
• When the camera switching pulse is recovered, "SW
LOSS" is cleared from the monitor.
30
ALARM
RESET
Auto Reset
The alarm is automatically reset after the programmed
Alarm Output Time has elapsed.
The ALARM indicator changes from blinking to steady light.
Pressing the ALARM RESET button will clear the alarm
and make the indicator go off.
External Reset
The alarm is reset by a recovery signal received from
the external equipment at pin 8 of the ALARM/REMOTE
connector.
The ALARM indicator changes from blinking to steady light.