Panasonic CY-VHD9401N Installation Instructions Manual page 9

Installation
E (continued)
N
G
L
I
S
H
11
Cut out
Rear side
Front side
1 Paper template
44
CY-VHD9401N
4
Cut out the paper template (1) printed on the
inside of the individual packing box.
5
Align the guide holes in the accessory paper
template (1) with the reference holes which
can be seen from the section that was cut
out from the headliner, and paste the paper
template onto the headliner using a tape or
other thing.
Note:
≥ Before cutting the headliner, check the
direction of the paper template to prevent any
mistakes in the installation position.
6
Pull out the wires that you pulled from the
pullout opening of the base plate beforehand so
that it will be easier to wire.
4
Get ready to attach the main unit.
Front cover
A
A A
6 Flat washer a 6
5 Spring washer a 6
4 Screw a 6
6 Flat washer
5 Spring washer
(5 mm‡)
(5 mm‡)
4 Screw (M5a25 mm)
1
Open the display unit and remove the 2 screws.
Place your fi ngers at A (in 2 places) on the
panel, and slowly pull down the panel.
Note:
≥ Be careful not to scratch the surface of the
front cover when removing it.
≥ The screws you remove now will be needed
when you re-attach it to complete installation.
Keep them in a place where they will not be
lost.
2
Insert the screws (4), fl at washer (6),
and spring washers (5) in the main unit.
Keep the screws only loosely tightened until the
unit is attached to the base plate.
* Depending on the type of vehicle for the
installation, you may not need to use some
space washers. When the space washers
are to be used, make absolutely sure
that their height will be the same in all
6 locations. Consult your dealer for details.
Caution:
≥ Before installing the unit, be absolutely
sure to check that the screws do not
make any contact with the ceiling panel.
If some space is required between the
base plate and the unit, attach and adjust
the under cover (page 40). For details on
installing the under cover, consult your
dealer.
CY-VHD9401N
E
N
G
L
I
S
H
12
45