Installation Guide; Supplied Hardware - Panasonic CY-VHD9401N Installation Instructions Manual

Installation Guide

E
N
G
L
I
S WARNING:
H
≥ Use in DC 12 V - ground vehicles. This
3 product is only for DC 12 V - grounded
vehicles. It cannot be used in DC 24 V
vehicles (such as large trucks, diesel
vehicles designed for cold climates, etc.).
Using this product in such vehicles could
cause fi re or other malfunction.
≥ Be sure to disconnect the battery's
- terminal while wiring and installing the
product. Doing the wiring and installation
with the battery's - terminal still connected
could cause electrical shock and injury due
to a short circuit accidents.
≥ Contact your car dealer or manufacturer
to determine the required procedure
and strictly follow their instructions
before attempting installation of this
product if your car is equipped with
air bag and/or anti-theft systems.
Specifi c procedures may be required for
connection and disconnection of the battery
to install this product. Failure to follow the
procedure may result in the unintended
deployment of air bags or activation of the
anti-theft system resulting in damage to the
car and personal injury.
Note:
≥ Various settings that have been stored in the
memory in other on-board equipment (car
navigation etc.) may be lost if the battery
terminals are disconnected.
Therefore, we recommend to make a record of or
to back up the settings before disconnecting the
terminals.
After completing installation of the main unit, set
the equipment again according to the record.
36
CY-VHD9401N

Supplied Hardware

For Installation
No. Item Diagram Q'ty
1 Paper template 1
Printed on the inside of
the box.
2 Under cover 1
3 Base plate 1
4 Screw 6
(M5k25 mm)
5 Spring washer 6
(5 mm‡)
6 Flat washer 6
(5 mm‡)
7 Screw (for resin) 6
(2.6 mm‡k8 mm)
8 Cord clamp 2
9 Power connector 1
Installation
WARNING:
Have a professional technician wire and install the product.
Professional skill and experience is required to wire and install the product. Improper installation could
result in failure of safety equipment resulting in accident and injury.
For safety's sake, always ask the store from which you purchased the product to install and wire it for
you.
Caution:
≥ Wear gloves for installation work to protect yourself from injuries. Failure to heed this caution may
result in an accident and/or injury.
≥ Wear goggles or protective eyewear to shield your eyes from airborne metal particles during drilling.
Failure to heed this caution may result in an accident and/or injury.
≥ When fi tting the product, using the supplied base plate, please ensure that it is properly secured to
avoid excessive vibration or the chance of the product coming loose and causing an accident.
≥ The metal plate, screws and nuts required to attach the base plate are not supplied.
The parts required for attaching the product differ depending on the vehicle type. Consult a
professional technician for more details, and always have a professional technician wire and install
the product for you.
Introduction
A sample installation is shown below for your reference.
First remove the headliner. Next, fi rmly attach the metal plate (option) and the base plate to the two ceiling
reinforcement crosspieces. Finally replace the headliner as it was and attach the main unit.
Wiring
Ceiling reinforcement
crosspieces
Metal plate (option),
base plate
CY-VHD9401N
CY-VHD9401N
E
N
G
L
I
S
H
4
37