Table of Contents
Advertisement
7
7.2
Specifying the Machine Settings
From the "MACHINE SETTING" menu, various settings for the machine's
operating environment can be specified. Refer to the following table for
details on each function.
No.
Name
1
AUTO RESET
2
POWER SAVE
MODE
3
DENSITY (ADF)
4
DENSITY
(BOOK)
5
PRINT
DENSITY
6
LCD
CONTRAST
7
LANGUAGE
8
LAMP OFF
TIME
9
BUZZER
VOLUME
0
INITIAL MODE
7-2
Description
Whether the Auto Reset function is disable or the time (0.5 min,
1 min, 2 min, 3 min, 4 min, or 5 min) until the machine is reset
after finishing copying/printing or after performing the last
operation can be selected. If the Auto Reset function is enabled,
all functions are automatically reset to their default settings.
• The factory default setting is 1 min.
If the machine performs no operations for a set length of time, it
will automatically enter the Power Save mode. The length of time
until the machine enters Power Save mode can be set between
1 min and 240 min (in 1 min increments).
• The factory default setting is 15 min.
The scanning density when using the Auto Document Feeder
can be adjusted.
Mode 1: For printing lighter copies of dark documents to avoid
darkening of copies.
Mode 2: For printing copies with same density as documents.
• The factory default setting is "Mode 1".
The density when scanning from the Original Glass can be
adjusted.
Mode 1: For printing copies with same density as documents.
Mode 2: For printing lighter copies of dark documents to avoid
darkening of copies.
• The factory default setting is "Mode 1".
The copy/print density can be adjusted to one of six levels
between –3 and +3. With the normal print density at 0, choose a
smaller number for a lighter print or choose a higher number for
a darker print.
• The factory default setting is "0" (Normal).
The brightness of the display can be set to one of four levels
between –1 and +2.
• The factory default setting is "0" (Normal).
The display language can be selected.
• The factory default setting is "English".
The time until the exposure lamp goes off can be adjusted.
Mode 1:When four hours have passed since the last operation
was performed
Mode 2:When the machine enters Power Save mode
• The factory default setting is "Mode 1".
This function can be used to set the volume of alarms and the
beep sounded when a key is pressed.
• The manufacturer's default setting is "LOW".
This function can be used to set the mode (Copy mode or Fax
mode) that the machine starts up in or returns to after the Control
Panel is reset.
• The manufacturer's default setting is "COPY".
Using the Utility Mode
7416MFG
Advertisement
Table of Contents
