Setting Date And Time - Panasonic HDC-TM10 Operating Instructions Manual

Preparation
7
Setup
When the unit is turned on for the first time, a message asking you to set the date and time will appear.
Select [YES] and perform steps 2 to 3 below to set the date and time.
¬ Change the mode to
1
Select the menu. (l 19)
[SETUP] # [CLOCK SET] # [YES]
2
Touch the date or time to be set,
then set the desired value using
/ .
≥ The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
≥ The 24-hour system is used to display the time.
appears on the right top of the screen
≥
when [SET WORLD TIME] is set to [HOME],
while appears when it is set to
[DESTINATION].
3
Touch [ENTER].
≥ The clock function starts at [00] seconds.
≥ A message prompting for World time setting
may be displayed. Perform the World time
setting by touching the screen.
≥ Touch [EXIT] or press the MENU button to
complete the setting.
20
VQT2D12 (ENG)

Setting date and time

.
Changing the date and time display mode
Select the menu. (l 19)
[SETUP] # [DATE/TIME] # desired display
style
[DATE]
[OFF]
≥ The date and time disappear from the screen
after being displayed for a few seconds.
Changing the date format
Select the menu. (l 19)
[SETUP] # [DATE FORMAT] # desired
display style
≥ The date and time function is driven by a
built-in lithium battery.
≥ If the time display becomes [- -], the built-in
lithium battery needs to be charged. To
recharge the built-in lithium battery, connect
the AC adaptor or attach the battery to this
unit. Leave the unit as it is for approx. 24 hours
and the battery will maintain the date and time
for approx. 6 months. (The battery is still being
recharged even if the power is off.)
[D/T]
15. 11. 2009
Display style
[Y/M/D] 2009. 11. 15
[M/D/Y] 11 15 2009
[D/M/Y] 15. 11. 2009
12:34
15. 11. 2009
Screen display