Quick Start] [Off]/[On - Panasonic HDC-HS700 Operating Instructions Manual

[QUICK START]
This unit will resume recording pause mode about 0.6 seconds after the LCD monitor is
reopened or the viewfinder is extended.
≥ Start time will not shorten if there is no SD card inserted.
Start time will be shorten if the [Built-inMemory] is selected in the [MEDIA SELECT], even if
there is no SD card inserted.
Start time will be shorten if the [HDD] is selected in the [MEDIA SELECT], even if there is
no SD card inserted.
≥ Change the mode to
1 Set [
QUICK START
2 Close the LCD monitor and retract the
viewfinder while the mode is set to
or .
The status indicator A flashes green and the unit
goes into quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor or extend
the viewfinder.
The status indicator A lights red and the unit
is put into recording pause.
≥ When in quick start standby mode about 80% of the power used in recording pause
mode is being consumed, so the recording time will be reduced.
≥ Quick start standby mode is cancelled if
j about 5 minutes elapsed
j mode is set to
≥ Time for quick start will be more than 0.6 seconds slower when digital cinema is used.
≥ Depending on the recording conditions, time for quick start may be more than 0.6 seconds
slower in still picture recording mode.
≥ It may take some time for automatic white balance to adjust.
≥ In the quick start mode, the zoom magnification becomes 1k.
≥ If [ECONOMY] (l 40) is set to [5 MINUTES] and the unit automatically goes into quick
start standby mode, close the LCD monitor and viewfinder and then open the LCD monitor
or extend the viewfinder again.
≥ Turn the unit off using the power button.
≥ Quick start standby mode cannot be released by the remote control.
[REMOTE CONTROL]
Please refer to page 47.
[OFF]/[ON]
or .
] to [ ].
ON
[OFF]/[ON]
41
VQT2N56