Before The First Use; Charging; Mounting The Wall Bracket - Lervia KH 4421 Operating Instructions Manual

KH4421

Before the First Use

1. The cordless hand vacuum cleaner is
powered by rechargeable Ni-MH bat-
teries. Before using the cordless hand
vacuum cleaner for the first time, the
batteries must be charged for at least
24 hours.
2. The batteries reach their full capacity
after a charging time of 24 hours.
Only place the appliance back in the
charging station
power becomes noticeably weaker.

Charging

1. Insert the round plug of the power
supply into the back of the charging
station . Lock the plug by turning it
anti-clockwise.
2. Place the charging station
a power socket and plug the power
adapter in.
The charging station can optionally
be mounted on a wall with the supp-
lied screws and plugs

„Mounting the wall bracket").

Vertical screw spacing 102 mm,
screw diameter 3,5 mm. The borehole
has to fit for plug diameter 5 mm
You can store the crevice tool
the upholstery brush
on the charging station
3. Place the hand vacuum cleaner in
the charging station
indicator light
the charging process begins.
once the vacuum
next to
(see Chapter
and
in the slots
.
.The charge
lights up red and
NOTE: Make certain that the on/off
switch is in position "0" before
starting the charging process.
Important:
• Once the charging process is comple-
ted, the appliance automatically swit-
ches to the charge maintenance func-
tion. However, in order to avoid possi-
ble damage to the batteries, do not
leave the appliance constantly con-
nected to the charging station .
• Only place the appliance back on the
charging station
power becomes noticeably weaker.
Important information about the
battery
In the event of a defective battery,
please contact our service centre di-
rectly. Please refer to the guarantee
card for the Authorized Service Outlet
in your country.
Mounting the Wall Bracket
1. Bore two holes with a spacing of
ca. 102 mm. Using the wall bracket
to mark the boreholes ensures the
correct spacing.
2. Push the plugs
and screw in the lower screw
ca. 3mm is protruding.
3. Place the wall bracket
screw.
4. Guide the upper screw
wall bracket
then screw it in.
5. Tighten both screws
- 6 -
once the vacuum
into the boreholes
until
on the lower
through the
and into the borehole,
down.