Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes; 3-Button Remotes - Chamberlain 2575C Owner's Manual

PROGRAMMING

NOTICE: If this Security ✚
measure in the receiver of the garage door opener, which provides security against code-theft devices, will be
circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or
supplier of the non-rolling code transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote
control. The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚

To Add or Reprogram a Hand-held Remote Control

USING THE "LEARN" BUTTON
1. Press and release the "learn"
button on the motor unit. The
learn indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press and
hold the button on the hand-held
*
remote that you wish to operate
your garage door.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs are
not installed, two clicks will be
heard.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote,
first erase all codes:
Press and hold the "learn" button on
motor unit until the learn indicator light
goes out (approximately 6 seconds). All
previous codes are now erased. Reprogram each
remote or keyless entry you wish to use.
® garage door opener is operated with a non-rolling code transmitter, the technical
USING THE MOTION DETECTING DOOR CONTROL
9 1 9 1
7 3 7 3
5 5
KG KG
1. Press and hold the button on the
hand-held remote
to operate your garage door.
2. While holding the ENTER button,
press and hold the LIGHT button
on the Motion Detecting Door
Control.
3. Continue holding the ENTER and
LIGHT buttons while you press
the push bar on the Motion
Detecting Door Control (all three
buttons are held).
4. Release buttons when the motor
unit lights blink. It has learned the
code. If light bulbs are not
installed, two clicks will be heard.

*3-Button Remotes

If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any
®
Security✚ 3-button
remote or compact
remote can be
programmed to operate
other Security✚ ®
garage door openers.
31
® remote controls.
*
that you wish