TABLE OF CONTENTS Introduction Adjustment 24-26 Operation 27-30 Assembly Installation 7-23 Programming 31-32 Repair Parts 33-34 Accessories Repair Parts and Service Warranty INTRODUCTION Safety Symbol Review serious injury or death...
ASSEMBLY STEP 3 Attach the Belt Cap Retainer You have now finished assembling your garage door opener. Please read the following warnings before proceeding to the installation section. INSTALLATION...
Page 8
INSTALLATION STEP 1 Determine the Header Bracket Location Proceed to Step 2, page 10.
Page 9
NOTE: If the total number of inches exceeds the height available in your garage, use the maximum height possible, or refer to page 10 for ceiling installation. Proceed to Step 2, page 10.
Page 10
INSTALLATION STEP 2 Install the Header Bracket...
Page 11
INSTALLATION STEP 3 Attach the T-Rail to the Header Bracket NOTE:...
Page 12
INSTALLATION STEP 4 Position the Opener...
Page 20
INSTALLATION STEP 11 Fasten the Door Bracket NOTE: Metal or light weight doors using a vertical angle iron brace between the door panel support and the door bracket: Metal, insulated or light weight factory reinforced doors: Wood Doors: NOTE:...
Page 22
INSTALLATION STEP 12 Connect Door Arm to Trolley...
PROGRAMMING ✚ To Add an Additional Hand-held Remote Control To Erase All Codes From Motor *3-Channel Remotes Unit Memory ✚ ✚...
Page 32
To Add or Change a Keyless Entry PIN NOTE: Your new Keyless Entry must be programmed to operate your garage door opener. NOTE: This method requires two people if the Keyless Entry is already mounted outside the garage. To change an existing, known PIN hours ✽...