Multiple Symbols - Honeywell 4600g User Manual

When the output sequence is Off , the barcode data is output to the host as the
imager decodes it.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Required
On/Not Required
*Off

Multiple Symbols

Note: This feature does not work when the Imager is in Low Power mode.
When this programming selection is turned On , it allows you to read multiple
symbols with a single pull of the Imager's trigger. If you press and hold the trig-
ger, aiming the Imager at a series of symbols, it reads unique symbols once,
beeping (if turned on) for each read. The imager attempts to find and decode
new symbols as long as the trigger is pulled. When this programming selection
is turned Off , the Imager will only read the symbol closest to the aiming beam.
On
* Off
3 - 20