Illumination Lights - Honeywell 4600g User Manual

If you have an aimer delay programmed (see
aimer will be at 100% power during the delay, regardless of the LED Power
Level.
Note: If you scan the Off barcode, both the aimer and illumination lights turn off,
making it impossible to scan barcodes in low light. To turn the LED Power
Level back on, move to a brightly lit area and scan either the Low or the
High barcode below.
Off
* High (100%)

Illumination Lights

If you want the illumination lights on while reading a barcode, scan the Lights
On barcode, below. However, if you want to turn just the lights off, scan the
Lights Off barcode.
Note: This setting does not affect the aimer light. The aiming light can be set
using Aimer Mode
* Lights On
3 - 10
(page 3-12).
Aimer Delay on page 3-11), the
Low (50%)
Lights Off