Table of Contents
Advertisement
5. Remove the HDD from the hard disk mounting
bracket.
6. Install the new HDD in the reverse order to when
replacing the hard disk drive.
7. After replacing the hard disk drive, insert the
power plug into the outlet and turn the power of
the unit on.
Notes:
•
When you install or replace the HDDs to the
hard disk mounting bracket, you must set the
HDD jumper to slave or master.
You must install the HDD as shown below.
-
Upper sides: Set the master HDD.
-
Lower sides: Set the slave HDD.
•
How and where to set the HDD jumper depends
on the manufacturer or model specification.
Therefore, carefully read the instructions printed
on top of the product or in the manual enclosed
with the product before installing the jumper.
-
If the jumper pin settings are identical with
each other in terms of priority, either HDD may
not be detected in the DVR or malfunction
may occur.
•
Make sure that each of the IDE cables is con-
nected to the connector housing through its holes.
•
Do not stack them nor keep them upright.
•
Do not use an electric screwdriver to fix them.
Recommended HDD
The following HDD has been tested and compatibility
is ensured. When you attach multiple HDDs use the
recommended HDDs.
Maker
RPM
Capacity Interface
7,200
80 GB
7,200
160 GB
Ultra
Hitachi
7,200
250 GB
ATA133
7,200
320 GB
7,200
500 GB
7,200
200 GB
Ultra
7,200
250 GB
Seagate
ATA100
7,200
300 GB
7,200
500 GB
Model No.
HDS728080PLAT20
HDT722516DLAT80
HDT722525DLAT80
HDT725032VLAT80
HDT725050VLAT80
ST3200827ACE
ST3250824ACE
ST3300822ACE
ST3500841ACE
19
Advertisement
Table of Contents
