Replacing The Hard Disk Drive; Recommended Hdd; System Operation; System Shutdown - LG LE5016 Series Owner's Manual

7. Connect the SATA cable to the SATA connector on the main
board.
8. Assemble the top case.
9. Fix the screws.
10. When you turn the power of the unit on, the new HDD is
detected and formatted automatically.

Replacing the Hard Disk Drive

Turn the power of the unit off and detach the power plug from the
outlet.
1. Follow steps 1 to 2 described in "Installing the Hard Disk Drive".
2. Remove the connector from the HDD.
3. Remove the screws from the hard disk drive on the left/right
side of the hard disk mounting bracket.
4. Remove the HDD from the hard disk mounting bracket.
5. Install the new HDD.
6. After replacing the hard disk drive, insert the power plug into
the outlet and turn the power of the unit on. The new HDD is
detected and formatted automatically.
NOTE
• Make sure that each of the SATA cables is connected to the
connector housing through its holes.
• Do not use an electric screwdriver to fix them.

Recommended HDD

The following HDD has been tested and compatibility is ensured.
When you attach multiple HDDs use the recommended HDDs.
NOTE
If you do not use the recommended HDD, the system may not be
operated normally.
Maker RPM Capacity Interface
7,200 250 GB
Seagate 7,200 500 GB
5,400 1 TB
Hitachi 5,700 1 TB
WD 5,000 2 TB
Model No.
SATA ST3250311SV
ST3500410SV
SATA
ST3500411SV
SATA ST31000424CS
SATA HCS5C1010CLA382
SATA WD20EURS63S48Y0

System Operation

1. Turn on the unit. System booting will commence. The LG logo
image will be displayed on the main monitor during the system
booting.
2. When the booting is complet the live window will be displayed.
Click the LOCK icon on the system control bar or press the LOCK
button on the remote control to display the log-in window.
3. Select a user name by using the mouse or arrow and the ENTER
button on the remote control or front panel. For the first time,
you can select the ADMINISTRATOR user name only. You can
register a new user with various access rights using the user
setup menu.
4. Enter the password by using the virtual keyboard. (Note that the
default administrator password is "000000".)
5. Press the LOCK button or click the [OK] icon.
You can see the live screen and operate the system.
NOTE
• This DVR is based on a VGA monitor using OSD. We
recommend to using the VGA monitor with this unit. If you
use a composite monitor, the OSD quality may be low to read
it.
• If the DVR is turned off accidently and then turned on again,
the DVR may take a long time to be rebooted.

System Shutdown

1. First, you must stop playback and exit the setup menu. In
playback, press STOP.
2. Press and hold 1 (POWER) button until the beep sounds and
the logout window will be displayed.
3. Enter the password by using the virtual keyboard.
4. Press the LOCK button or click the [OK] icon. The system will
shutdown.
Installation 19
3