Setting Up The Hands-Free Phone - Kenwood DDX6054 Instruction Manual

Hands Free Unit Control

Setting Up the Hands-Free Phone

The Hands-Free system can be set as follows.
1 Display the Hands-Free Control screen
See <Making a call> (page 44).
2 Display the Hands Free Setup screen
3 Set each item
[Auto Response] Sets an automatic response
time after call termination. (
"OFF": This function can not use.
"0-99": Sets to calling ring time (second).
[Phone Voice] Sets a ringing tone output
position. ( "Front All")
"Front L": Outputs the tone from the front left-
hand side speaker.
"Front R": Outputs the tone from the front
right-hand side speaker.
"Front All": Outputs the tone from the both
front speakers.
48
DNX7240BT/DDX6054
⁄
"OFF")
• Either the time interval for automatic answer set on this
unit or the time interval set on the cell-phone, whichever
is shorter, takes effect.
• Select the speaker which is further from the microphone
in order to prevent howling or echoes.
[Call Beep] Sets the beep of the incoming call.
( "ON")
"ON": Beep is heard.
"OFF": Beep is canceled.
[SMS Receive Beep] Sets the beep of the
incoming SMS. ( "ON")
"ON": Beep is heard.
"OFF": Beep is canceled.
[Phone Information Use] Sets whether to
use cell-phone phonebook, outgoing calls list,
incoming calls list and missed calls list.
( "ON")
"ON": Yes.
"OFF": No.
[SMS Use] Sets the SMS function. (
"ON": Use SMS function.
"OFF": SMS not available.
[Key Word] Registers the voice to select phone
number category with voice recognition.
See <Key Word Voice Registration> (page 49).
[Use Phone Voice Recognition] Sets whether
to dial using the phone voice recognition
function. ( "ON")
[Echo Cancel] Sets whether to cancel echo.
( "ON")
[Microphone Level] Adjusts the sensitivity of
the built-in microphone for a telephone call.
( "6")
[Noise Reduction] Reduces the noises
generated by the surrounding environment
without changing the microphone volume.
( "ON")
[Restore] Restores the [Echo Cancel],
[Microphone Level], or [Noise Reduction] value
to the initial value.
"ON")