Zanussi ZKI 245 User Manual page 21

Malfunction
Spinning starts late or the machine
does not spin:
The machine makes an unusual noise
No water is visible in the drum
The machine does not dry or does not dry
properly
Possible Cause / Solution
The electronic unbalance detection device has cut in
because the laundry is not evenly distributed in the
drum. The laundry is redistributed by reverse rotation
of the drum. This may happen several times before
the unbalance disappears and normal spinning can
resume. If, after 10 minutes, the laundry is still not
evenly distributed in the drum, the machine will not
spin. In this case, redistribute the load manually and
select the spin programme.
Redistribute the laundry.
●
The load is too small.
Add more items, redistribute the load manually and
●
then select the spinning programme.
The machine is fitted with a type of motor which
makes an unusual noise compared with other
traditional motors. This new motor ensures a softer
start and more even distribution of the laundry in the
drum when spinning, as well as increased stability of
the machine.
Machines based on modern technology operate very
economically using very little water without affecting
performance.
The drying time has not been selected.
• Select the drying time.
The water tap is not turned on (E10)
• Open the water tap.
The drain filter is clogged (E20)
• Clean the drain filter.
The machine is overloaded.
• Reduce the laundry load.
The selected drying time was not suitable for the
laundry.
• Select the suitable drying time for the laundry.
21