Adjusting The Volume; Reinforcing The Bass Sound - JVC RC-BZ6BU Instructions Manual

When power is supplied from the batteries:
When the Unit is turned off with the
button on the Remote Control is ineffective), the Standby in-
dicator goes out and the display is blank, except for the clock dis-
play. Further, the backlight for the display goes out.
To switch off the Unit completely, remove the batteries from the
Unit.

Adjusting the Volume

You can adjust the volume level between 0 and 25 when the Unit is
turned on.
Turn the VOLUME control on the Unit to the right or left to in-
crease or decrease the volume level.
Press the VOLUME + or – button on the Remote Control to increase
or decrease the volume level.
CAUTION: DO NOT turn on the Unit and/or start
playing any source without first setting the
VOLUME control to 0, as a sudden blast of sound
can damage your hearing, speakers and/or head-
phones.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers.
Be sure to turn down the volume before connecting or putting on
headphones.

Reinforcing the Bass Sound

(AHB PRO)
You can reinforce the bass sound to maintain rich, full bass at low
volume (you can use this effect only for playback):
To get the effect, press the AHB (Active Hyper Bass) PRO
button.
The "AHB PRO" indicator lights up on the display.
To cancel the effect, press the button again.
The "AHB PRO" indicator goes out.
Sound Effects (SOUND)
The System has the following preset sound effects that give you
control over the way your music sounds, so you can tailor it to the
acoustics of your room and the quality of your source. Test the
sound effects out to hear how each affects the music. Note that the
effects work only during playback.
Sound effects
FLAT: No sound effect.
BEAT: Boosts low and high frequencies.
POP: Good for vocal music.
CLEAR: For a wide, dynamic stereo sound.
To get an effect, press the SOUND button repeatedly until the
Sound mode you want appears on the display.
Each time you press the SOUND button, the display changes as
shown below:
BEAT POP
To cancel the effect, press the SOUND button until "FLAT" ap-
pears on the display.
4
button on the Unit (the
OR
CLEAR FLAT
Showing the Time (DISPLAY)
In standby mode, both a digital and an analog are displayed.
In Standby mode, both clocks are displayed on the display.
When the Unit is turned on, the analog clock only is displayed.
To display both clocks while the Unit is turned on, press
the CLOCK/TIMER button on the Unit.
To return to the original display, press the CLOCK/TIMER
button on the Unit once again.
Digital clock
Note: You need to set the clock first in order for it to work. (See
"Setting the Clock" on page 9.)
Analog clock