Maytag MER6769BAQ Installation Manual page 7

3-WIRE SERVICE CORD OR CONDUIT INSTALLATION
1. Insure that the copper ground strap IS CONNECTED
between the middle post of the main terminal
connection block and the range chassis.
the service cord or conduit connect to the outside
posts of the main terminal connection block. Polarity is
unimportant.
2. The middle wire of the service cord or ground lead of
3-wire conduit MUST connect to the neutral (middle)
post of the main terminal block. The other two wires of
3. A appropriate strain relief for service cord or conduit
must be attached to the conduit plate.
WHITE
GROUND
(CONNECTED AT
FACTORY)
RELIEF
FLOOR
MAIN TERMINAL
CONNECTION BLOCK
MIDDLE WIRE OF
SERVICE CORD
OR GROUND LEAD
OF CONDUIT
STAMPED
CONDUIT
CONDUIT
PLATE
FOR USE WITH CONDUIT.
STAMPED REMOVE BRACKET. FLIP
CORD & RE-AT[ACH WITH HOLE
MARKED "CONDUIT"
DOWN.
OUTLET RECEPTACLE TO BE
ROTATED AS SHOWN IF NOT_
"LUSH TO WALL
)UTLET RECEPTACLE
MOUNTED FLUSH TO
FLOOR
FIGURE 7
ACCEPTABLE 3-WIRE PLUG INSTALLATION
-7-