Maytag MIT8795BS00 Installation Instructions Manual page 8

Style 2: Direct wire strain relief
• Use Phillips screwdriver to remove screws and slide
cord/conduit plate down and out.
• Position cord/conduit plate as shown in the following
illustration.
• Replace cord/conduit plate and insert screws.
/ ..............
• Assemble a UL listed conduit connector in the opening.
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
Tighten strain relief screw against the flexible conduit.
5. Replace back panel and screws on rear of range.
6. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Electrical Connection Options
If your home has: And you will be Go to Section:
connecting to:
4-wire receptacle
(NEMA type 14-50R)
A UL listed,
250-volt
minimum,
40-amp, range
power supply
cord
4-wire connection:
Power supply cord
4-wire direct
(12.7 cm)
A fused
disconnect or
circuit breaker
box
4-wire connection:
Direct wire
3-wire receptacle
(NEMA type 10-50R)
A UL listed,
250-volt
minimum,
40-amp, range
power supply
cord
3-wire connection:
Power supply cord
3-wire direct
1 it
(7.6 crn)
A fused 3-wire connection:
disconnect or Direct wire
circuit breaker
box
t
A. Removable retaining nut
B. Strain refief
8