Maytag MGR7661WS0 Installation Instructions Manual page 13

To Convert Surface Burners
1. Remove burner cap.
2. Using a Phillips screwdriver, remove the burner base.
NOTE: Reinstall one of the screws through the range cooktop
to hold the orifice spud holder in place while removing and
replacing the orifice spuds.
B
3,
A. Igniter electrode
B. Gas tube opening
C. Burner cap
D. Burner base
Apply masking tape to the end of a 5/le" nut driver to help hold
the gas orifice spud in the nut driver while changing it. Press
nut driver down onto the gas orifice spud and remove by
turning it counterclockwise and lifting out. Set gas orifice
spud aside.
A
D
LP Gas Orifice Spud Chart for Surface Burners
Burner Rating Color Size ID Number
14,000 BTU Yellow/Orange 1.07 mm L107
11,000 BTU Yellow/Brown 0.99 mm L99
8,000 BTU Yellow/Black 0.85 mm L85
5,000 BTU Yellow/White 0.70 mm L70
NOTE: Refer to the Model Number and Serial Number Plate
located behind the left side of the storage or warming drawer for
proper sizing of spuds for each burner location.
5. Place Natural gas orifice spuds in the cardboard orifice spud
holder.
6. Replace the burner base using both screw.
7. Replace burner cap.
8. Repeat steps 1-7 for the remaining burners.
To Convert Oven Bake Burner
1. Remove oven racks.
2. Use a 1/2" combination wrench to turn the orifice hood down
snug onto pin (about 2 to 21/2turns).
IMPORTANT: Do not overtighten.
The oven bake burner flame cannot be properly adjusted if
this conversion is not made. See "Adjust Oven Bake Burner
Flame" in the "Electronic Ignition System" section.
A. Orifice hood
B. Pin
4,
A. Orifice spud
B. Orifice spud holder
C. Screw
D. Spark electrode
Remove the cardboard orifice spud holder located on the
back of the range near the gas inlet. Gas orifice spuds are
stamped with a number, marked with 1 color dot, and have a
groove in the hex area. Replace the Natural gas orifice spud
with the correct LP gas orifice spud.
To Convert Oven Broil Burner
Use a 1/2"combination wrench to turn the orifice hood down snug
onto the pin (about 2 to 21/2turns).
IMPORTANT: Do not overtighten.
The oven broil burner flame cannot be properly adjusted if this
conversion is not made. See "Adjust Oven Broil Burner Flame" in
the "Electronic Ignition System" section.
A. Groove
Refer to the following chart for correct LP gas orifice spud
placement.
/
/
/
A. Lock screw
B. Orifice hood
13