Table of Contents
Advertisement
HOW TO SET AND ACTIVATE THE
ALARM
To set the Alarm
AL AL
AL AL /
Press [AL
] button to display the daily alarm time (the icon "AL"
will be displayed)
AL AL
AL AL /
Press [AL
] and hold for three seconds, the value for the hour
will flash.
Press UP(+) or DOWN(-) buttons to make changes to the alarm
hour setting.
AL AL
AL AL /
Press [AL
] and the minute will flash. Enter the value for
the minute by using UP(+) or DOWN(-) buttons.
AL AL
AL AL /
Press [AL
] to exit.
The alarm is automatically activated. The ALARM ON icon [ ] is
visible and the alarm will activate at the specified time.
To deactivate the daily alarm function, press the DOWN(-) button
when the alarm time is displayed. The ALARM ON icon will
disappear and [ -:-- ] will be displated. To activate, press the UP (+)
button to display the alarm time again.
ALARM AND SNOOZE FUNCTION
When the daily alarm goes off alarm, the backlight will be on for
five seconds and the ALARM ON icon will flash.
The alarm function has a built in crescendo type alarm system.
Initially, the active alarm will have a gentle sound. The intensity
will increase in three stages. Without interruption, the unit will
alarm for two minutes.
To stop the alarm, press any button (expect MEMORY &
CHANNEL). However, if the [
SNOOZE function will be triggered. The alarm will stop and the
ALARM ON icon blinks for eight minutes. After that the alarm will
go off again. To deactivate the SNOOZE function, press the ALARM
button.
913hg-e.p65
PRE-ALARM FUNCTION FOR CHANNEL
The alarm function also has a pre-alarm feature which can alert the
user before their preset alarm time if weather conditions changes.
This pre-alarm function applies to Channel 1 Remote Sensor only.
To enable this function, first activate the alarm function. Then enter
the Pre-Alarm mode by pressing the ALARM button twice. The
"Pre-Al" icon will be displayed.
Press and hold the ALARM button for 3 seconds to set the operating
time interval for this pre-alarm function. Use the UP or DOWN
button to select from the 4 time-intervals: 15, 30, 45 or 60 minutes.
Press the ALARM button to confirm and exit. The pre-alarm
function will be enabled automatically which is indicated by the
appearance of the [ ] symbol.
To disable this function, press the DOWN button in the Pre-Alarm
mode. The [ ] symbol will disappear and "-:--" will appear to
indicate disable of this function.
The pre-alarm will operate during the selected time interval before
the daily alarm time. For example, if the daily alarm is set to go off
at 7:00 am and the pre-alarm operating time interval is set to 45
minutes, the pre-alarm will start to operate at 6:15 am (45 minutes
before 7:00 am).
During the pre-alarm operating period, if the temperature recorded
at Channel 1 remote sensor falls to or below 2.0ºC, the pre-alarm
will be triggered. The Pre-Alarm icon will flash and the backlight
] bar is pressed, the
will be turned on for 5 seconds. An alarm sound will also go off for
2 minutes as that of the daily alarm and the snooze function will
also be activated if the [
6
6
1 REMOTE SENSOR
] bar button is pressed.
04/30/2002, 5:59 PM
Hide quick links:
Advertisement
Table of Contents
