Maytag MGD6000XG0 Installation Instructions Manual page 16

DOOR (OPTION )
The following instructions are for models with a round-shaped
door.
IMPORTANT: For models with a square shaped door, an
additional kit is needed. Please contact your retailer, or see the
For Assistance or Service page in your Use and Care Guide.
Tools needed:
@
Min. 8" long Torx ®T25
screwdriver
#2 Phillips screwdriver
f2. Move the door strike
®
®
®
®
Using a Torx ®t T25 screwdriver
®
®
®
®
remove the 2 screws securing
the door strike to the door frame of the dryer. Rotate the
strike 180 ° and attach to the opposite side of dryer door
frame, as shown.
IMPORTANT: If the protective film has not yet been
removed from the dryer, peel the film from the dryer
door before proceeding.
Using a Torx ®T25 screwdriver, remove the 4 screws securing
the door hinge to the dryer and lift up and out to remove the
door. Place the door on a soft towel or other non-scratch
surface. Reinstall the 4 screws in the holes.
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
-_® TORX isa registered trademark of Saturn Fasteners, Inc.
16