Your Safety First
BEFORE
YOU START
• Proper
installation
is the installer's
responsibility!
- Read the entire manual before you begin. The model number label is located on the oven front.
See Figure 1. The mounting plate is located on back side of microwave oven. See Figure 2.
NOTE: Vent grille appearance varies by model.
BE SURE TO READ THE FOLLOWING
SAFETY
INSTRUCTIONS:
Model Number Plate
Label Cooking Guide
Mounting Plate
Figure 1
Figure 2
WARNING,
For Your Safety
• You will need TWO people to install this oven. It is heavy and could cause personal
injury if not handled
properly.
• Avoid
Electrical
Shock!
- Before you drill into the wall, note where electrical outlets are and where electrical wires might be concealed
behind the wall. YOU COULD GET AN ELECTRIC SHOCK if you contact electrical wires with your drill bit.
- Locate and disconnect the power to any electrical circuits that could be affected by installing this oven.
IF YOU DO NOT DISCONNECT
THE POWER, YOU COULD GET AN ELECTRIC SHOCK.
• ELECTRICAL
RATING
OF THIS OVEN
: 120V AC 60Hz.
- You need a DEDICATED
120V, 60Hz, AC only, 15 or 20A, fused electrical supply (located in the cabinet
above the microwave as close as possible to the microwave) serving only the microwave.
-2-