LG LMV1680BB Installation Instructions Manual page 11

STEP 3: Prepare The Ventinc/ Blower
WALL-VENTED INSTALLATION:
1. Remove one blower unit mounting screw and one or
several blower plate mounting screw(s). Remove the
blower plate from cabinet. See Figure 13.
2. Carefully lift the blower unit out of the microwave oven.
3. Use side cutters or tin snips to cut and remove knockouts
B from Back plate, Discard knockouts• Be careful not to
distort the plate, See Figure 14.
4. Reassemble the blower wire. See Figure 15.
6. Rotate the blower unit so that the exhaust ports face the
rear of the cabinet. See Figure 16.
6. Place blower unit back into cabinet. Check that the exhaust
ports face towards the rear of the cabinet. Be sure the
wires are not pinched. See Figure 17.
7. Reattach the blower plate to cabinet so the exhaust pods
and blower plate opening are aligned, Attach with one
blower unit mounting screw and then one or several blower
plate mounting screw(s). See Figure 18.
BlowerPlate
l i MountingScrew
i :
...... BlowerPlate
BlowerUnit_- Back Plate
._ BlowerUnit
o°_n_ Screw
Figure 13
Figure 14
Blower
Unit
Figure 15
\
Exhaust Ports
Figure 16
,_ Blower Plate
• [ [ Mounting Screw
i
Back Plate
Exhaust
Ports
Figure 17
Blower Unit
Blower Uni Mounting Screw
Exhaust Ports
Figure 18
-11 -