Prepare Cabinet Opening Where There Are No Existing Utility Hookups - KitchenAid KUDS03FTPA Installation Instructions Manual

Option 2: No waste disposer = with air gap:
1. Cut end of drain hose if needed {do not cut ribbed
section),
2. Attach drain hose to air gap with large spring-type
clamp. If the drain hose was cut, use a 1-1/2" to 2"
(3.8 to 5 cm) screw-type clamp x-,
3. Use a rubber hose connector _ with spring or screw-
type damps .× to connect air gap to waste tee.
This connection must be before the drain trap and at
least 20" (50.8 cm) above the floor where dishwasher
will be installe&
drain hose-
_ cut here if needed
_g or
rubber hose
connector
large
spring-type
drain
drain trap hose
|
insert drain hose |
through hob cut in
cabinet to the front
center of opening where
drain connection wiil be
made.
Parts available from local plumbing supply stores
drain hose
Option 3: Waste disposer - no air gap:
1. Remove the disposer knockout plug. Do not cut end of
drain hose.
Attach drain hose to disposer inlet with large spring-
type clamp.
This connection must be before the drain trap and at
least 20" (50.8 cm) above the floor where dishwasher
will be installed, it is recommended that the drain hose
be looped up and securely fastened to the underside of
the counter.
large spring-type
clamp
drain hose
disposer
inlet
drain trap
!
insert drain hose |
through hob cut in
cabinet to the front
center of opening where
drain connection will be j
made.
/
drain hose
Option 4: No waste disposer = no air gap:
1. Cut end of drain hose if needed (do not cut ribbed
section),
2. Attach drain hose to waste tee with 1-1/2" to 2"
(&8 to 5 cm) screw4ype clamp ×,
This connection must be before the drain trap and at
least 20" (50,8 cm) above the floor w,here dishwasher will
be installed. It is recommended that the drain hose be
looped up and securely fastened to the underside of the
counter.
drain hose -
_/ cut here if needed
screw4ype clamp
J
teeWaSteJ
drain trap
3. Insert drain hose through /
hole cut in cabinet to the
front center of opening
where drain connection
will be made_
Parts available from local plumbing
supply stores
drain hose
hose
Prepare cabinet opening where there
are no existing utility hookups
Electrical connection
Option1: Direct wire method:
HelpfuJTip: Wiring the dishwasher will be easier if you
route wire into the cabinet opening from the right side.
1. Drill a 3/4" (1,9 cm)
hole in right-hand optional preferred
cabinet side, rear or locations locations
floor. Preferred and
optional locations are
shown.
2. Wood cabinet: Sand
hole until smootL
Metal cabinet: Cover
hole with grommet,
not provided.
3. Run wire into house wiring junction box.
4. Install a U.L.-listed/CSA-certified clamp connector (strain
relief) for flexible-type wire. If installing conduit, attach a
U.L.-listed/CSA-certified
conduit connector to the
junction box.
5. Run other end of wire
through cabinet hole.
must extend to the right
front of cabinet opening.