Make Ejectmcai Connection - KitchenAid KUDS03FTPA Installation Instructions Manual

Move dishwasher into cabinet opening
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
4=
5.
1. Grasp the sides of the dishwasher at the edges of the
door panel.
2. THt dishwasher backwards on wheels and move
dishwasher close to cabinet opening. Do not push on the
front of the panel or on the console--they may dent.
3. if dishwasher has a power supply cord, insert power
supply cord into hone cut into cabinet.
if using direct wire, check that it is on the right front side
of opening.
Check that water line is on the left side of opening and
drain hose is near the center of the hole in the cabinet.
Slowly move dishwasher
completely into cabinet opening,
Do not kink or pinch copper
tubing, drain hose, power supply
cord or direct wire between
dishwasher and cabinet.
HeJpfuJ Tip: Once the dishwasher
is in position, you may have to
support the front of the
dishwasher by raising, lowering or shimming front feet.
Remove cardboard from under dishwasher.
NOTE: It is all right if dishwasher fits tightly into cabinet
opening. Do not remove insulation blanket --the blanket
reduces the sound level.
LeveU the dishwasher
Align front of dishwasher door panel with cabinet doors.
You may need to adjust alignment to be even with your
cabinets.
He[pfu[Tip: Prop up one side of frame to hold
dishwasher up off floor when adjusting front legs.
Check that leveling legs are firmly against the floor.
3. Close and latch the door, and place level against the
front panel. Check that dishwasher is plumb. If needed,
adjust leveling leg or add shims under rear wheel until
dishwasher is plumb.
4. Repeat for other side of dishwasher.
NOTE: Shims must be securely attached to floor to prevent
their movement when the dishwasher is operated.
5. Place level against top front
opening of tub. Check that
dishwasher is level from side to
side. If dishwasher is not level,
adjust front legs up or down
until dishwasher is level.
Make EJecttieaJ Connection
Check "Electrical requirements" section.
You need to:
o have the correct electrical supply and recommended
grounding method.
If you are:
o direct wiring, use Option 1
o using a power supply cord, use Option 2
Option 1: Direct wire method
1. Route direct wire so that it does not touch dishwasher
motor or lower part of dishwasher tub.
2=
Pull direct wire through hob in terminal box.
Helpful Tip:
o Select the proper size twist=on
connectors to connect your
household wiring to 16-gauge
dishwasher wiring.
o insert wire ends into twist-on
connector. Do not preotwist bare wire.
oTwist connector.
o Gently tug on wires to be sure both are secured.
16