Hoover HGD 640 SGH User Instructions page 4

INSTRUCTIONS FOR THE INSTALLER
INSTALLATION
The Purchaser is responsible for the installation of the hob. The Manufacturer does not
accept any responsibility for any damage or loss resulting from incorrect installation,
and as such this will not covered by the Manufacturer's Guarantee.
The hob may be installed in any worktop which is heat resistant to a temperature of
100° C, and has a thickness of 25 - 45 mm. The dimensions of the insert to be cut out
of the worktop are in shown in Fig. 1.
If the Hob is fitted next to a cabinet on either side, the distance between the Hob and the
cabinet must be at least 15 cm (see Fig. 2); while the distance between the hob and the
rear wall must be at least 5,5 cm.
The distance between the hob and any
other unit or appliance above it (e.g. An ex-
tractor hood) must be no less than 70 cm
(fig.2).
When there is an accessible space between
the built-in hob and the cavity below, a divi-
ding wall made of insulating material should
be inserted (wood or a similar material).
The wall should be at least 10 mm away from
bottom of the drawer. (fig. 3)
Important - The diagram below shows
how the sealant should be applied.
Plan 60 Plan 75
The Hob unit is fitted by attaching the Fixing Clamps supplied, using the holes at the base
of the unit.
Fig. 1
accessible space
Fig. 2
Fig. 3
GB IE
3