TECHNICAL CHARACTERISTICS Tab. 1 BUILT IN HOBS Burners/hotplates 5 gas 4 gas Type / reference PL73/PL74 PL03/PL04 Flame failure device - / yes - / yes Fish burner PES DC ø 110 mm Double ring burner UR ø 110 mm Ultra rapid burnes SR ø...
Page 4
INSTRUCTIONS FOR THE INSTALLER INSTALLATION The Purchaser is responsible for the installation of the hob. The Manufacturer does not accept any responsibility for any damage or loss resulting from incorrect installation, and as such this will not covered by the Manufacturer’s Guarantee. The hob may be installed in any worktop which is heat resistant to a temperature of 100°...
If a hob of 60 cm is fitted above an oven which is not equipped with fan cooling system it is recommended that openings are created within the built in furniture to ensure cor- rect air circulation. The size of these openings must be at least 300 cm and placed as shown in fig.
ELECTRICAL CONNECTION Warning - this appliance must be earthed This appliance is designed for domestic use only. Connection to the mains supply must be made by a competant electrician, ensuring that all current regulations concerning such installations are observed. The appliance must only be connected to a suitably rated spur point, a 3 pin 13 amp plug/socket is not suitable.
Page 7
ELECTRICAL CONNECTION Check the data on the rating plate, located on the outside of the unit, to ensure that the supply and input voltage are suitable. Before connection, check the earthing system. By Law, this appliance must be earthed. If this regulation is not complied with, the Manufacturer will not be responsible for any damage caused to persons or property.
To prevent any potential damage to the hob please carry out the installation following this sequence: 1/2 GAS CONICAL A) As illustrated, as- 2) Tighten the joints 3) Attach fitting C to semble parts in se- with the Spanners, mains gas supply us- quence: remembering to twist ing rigid copper pipe...
X dimension according Table of gas consumption 1W = 0,860 kcal/h to Gas type G20 20mbar G20/G25 G30 29mbar 25mbar G31 37mbar Working Ø gas jet Ø gas jet STD. Dim min.Dim reg. reg. reg. reg. burner 1/100 mm 1/100 mm large 2,65 0,65...
When you have carried out the new gas regulation, replace the old gas rating pla- te on your appliance with one (supplied with hob) suitable for the type of gas for which it has been regulated. USE OF HOB USER INSTRUCTIONS This appliance must only be used for the purpose for which it is intended, domestic cooking, and any other use will be considered improper and could therefore be danger- ous.
MAINTENANCE AND CLEANING Before cleaning the Hob, ensure the appliance has cooled down. Remove the plug from the socket or (if connected directly) switch off the electricity supply. When cleaning the enamelled, varnished or chrome sections, use warm soapy water or a non caustic detergent.