Helpful Hints - One for All LITE URC-2589 User Manual & Code Book

Trouble-Shooting

Helpful Hints

Problem:
Red light does not blink
when you press a key?
The ONE FOR ALL does
not respond after
pressing a key?
The ONE FOR ALL does
not operate your
device(s)?
Your brand is not listed
in the ONE FOR ALL
code section?
When following the
set-up instructions, the
red light on the ONE
FOR ALL only blinks once
instead of twice after you
enter a three-digit code?
The ONE FOR ALL is not
preforming commands
properly?
Press a key but get the
wrong result?
You cannot control
the volume feature of
your Satellite, Cable
Converter or TV/ Video
combination OR you
cannot control the
volume of the TV set up
on the AUX key?
Problems changing
channels?
Video not recording?
Solution:
Replace batteries with 4 fresh,
new AAA alkaline batteries.
Make sure you are using new
batteries and are aiming the
ONE FOR ALL at your device.
A) Try all the codes listed for
your brand. B) Try the search
method on page 15.
Try the search method on page
15.
Did you use the Code Lock
feature? You must first unlock
the code before entering a new
code. Follow the instructions
on page 14 to do this.
You may be using the wrong
code. Start the search method
over again to locate the proper
code.
Hold MAGIC until the red light
blinks twice, then press 992
and the device key twice. You
will need to set-up your device
again. Try the codes for brand
or the search method on page 15.
Hold MAGIC until red light
blinks twice. Then press 993
and VOL+. To set the volume
control back to TV (Punch
Through), hold MAGIC until
the red light blinks twice, then
press 993 TV.
Enter the programme number
exactly as you would on your
original remote.
As a safety feature on your ONE
FOR ALL, you must press the
Record key twice.
17