Trouble-Shooting; Helpful Hints - One for All URC-6532 User Manual

Helpful Hints

Problem:
Your brand is not listed in the
ONE FOR ALL code section?
The ONE FOR ALL does not
operate your device?
The ONE FOR ALL is not
performing commands
properly?
Your TV switches to
programme 1 when you press
the POWER key before
switching off OR you must
press POWER twice to switch
on your TV?
You cannot reach channel 10
and above on your TV or
Satellite.
Video not recording?
The ONE FOR ALL does not
respond after pressing a key?
The red light does not blink
when you press a key?
WWW.ONEFORALL.COM

Trouble-Shooting

Solution:
Try the search method.
A) Try all the codes listed for your
brand. B) Try the search method.
You may be using the wrong code.
Try Direct Set-Up again trying each
code listed under your brand or start
the search method over again to
locate the proper code.
Press TV, then press MAGIC until the
red light blinks twice.
Then press:
(Programme-)
(Programme+)
(Programme-)
If your original remote did not have
channel +/- keys, the Zapper may not
operate this function.
As a safety feature on your ONE FOR
ALL, you must press the Record key
twice.
Make sure you are using new
batteries and are aiming the ONE
FOR ALL at your device.
Replace batteries with 2 new
"AAA/LR03" alkaline batteries
11