Style 2: Install Custom Overlay Drawer Panels - KitchenAid KDDA27TRS00 Installation Instructions Manual

If you have Style 1: Standard refrigerator drawers, skip this step.
Go to "Install the Mounting Brackets" to continue the installation.
IM PO RTANT:
• Create custom overlay drawer panels according to the
specifications in the "Style 2: Custom Overlay Drawer
Panels" section.
• KitchenAid is not responsible for the removal or addition of
decorative panels that would prevent the refrigerator drawers
from being serviced.
Remove the Gaskets
IMPORTANT: The gaskets contain strong magnetic strips. Follow
these instructions and keep screws and other loose metal parts
away from the gaskets to prevent damaging them.
1. Begin at the top right corner. Slowly pull the gasket out of the
corner and continue working slowly toward the opposite side
as shown.
Remove the Drawers
1. Disconnect the wiring plug located on the left side of the
drawer (top drawer only) as shown.
A
2=
A. Drawer front
B. Wiring plug
Using a Phillips screwdriver, remove the two screws located
on each side of the drawer to release it.
NOTE: Do not discard the screws. Set them aside for later
use.
A
2. Proceed slowly from corner to corner until the gasket is
completely free from the groove.
3. Gently remove the gasket and lay it aside on a clean, soft
working surface. Be sure to keep all screws and loose metal
parts away from the magnetic gasket.
4. Repeat the process for the other gasket.
Remove the Drawer Fronts
1. Remove the drawer front by removing the three screws
located across the bottom and the two screws located on
each side of the drawer as shown.
NOTE: Do not discard the screws. Set them aside for later
use.
3=
4.
5.
A
A. Screws
Remove the drawer by lifting it up and sliding it forward.
Push the empty drawer slides back into place.
Repeat the process for the other drawer.