Install Overlay Series Custom Panels - KitchenAid KSSC36FTS Installation Manual

1. Use a %s" socket driver to turn the leveling bolts clockwise to
extend the legs to the floor as shown. The rollers should be off
the floor.
A B/_°°l'_=''_'_d
A. Rear leveling bolt
B. Front leveling bolt
2.
3.
Adjust the leveling legs to level and align the refrigerator from
left to right and front to back so that the refrigerator is level
and aligned with the cabinetry. The cabinetry surface must be
plumb for the ideal fit of the refrigerator side trim.
Continue adjusting all of the leveling legs to raise the
refrigerator until the top is within at least 1" (2.54 cm) of the
top soffit.
NOTE: If an anti-tip board has been used, adjust the leveling
legs until the top of the refrigerator is within 1/4"(6.35 mm) of
the bottom of the anti-tip board as shown. Do not crush the
compressor cover.
A B
2" (5 cm)
1/4" (6 mrn)
max.
4=
D
A. Center board ¼" (6.35 mm) max. above refrigerator
B. 2" x 4" x 32" (5 cm x10 cm x 81 cm) boards (2)
C. Attach to studs with six #8 x 3" (7.6 cm) screws
D. Compressor cover
IMPORTANT: Adjust in small increments to keep from
damaging the cabinet trim and causing problems with
the door alignment or top grille fit. To avoid damage to
the cabinet or leveling legs, do not apply more than
50 inch-pounds (5.65 Nm) of torque to the leveling bolts.
The leveling legs can be extended to a maximum of 11/4"
(3.18 cm) below the rollers.
For Overlay models, additional adjustments may be needed
after the custom panels are installed.
Install Overlay Series Custom Panels
IM PORTANT:
Install the custom handles prior to installing the panels on the
refrigerator. For more information on KitchenAid custom
handle selection, refer to the KitchenAid Catalog, visit
www.kitchenaid.com, or call 1-800-442-9991. In Canada,
visit www.KitchenAid.ca, or call 1-800-807-6777.
Create custom door overlay panels according to the
specifications in the "Overlay Series Custom Panels" section.
KitchenAid is not responsible for the removal or addition of
molding or decorative panels that would not allow access to
the refrigerator for service.
Door Panel Installation
1=
2.
3.
Remove all tape and door bracing from the refrigerator and
freezer doors.
Open the refrigerator and freezer compartment doors.
Remove the handle-side and top trims.
A_
IIIIIIIMMMMIIIIIIIIIIIIMMMMIII
4=
A. Trims
Slide the custom panels into the bottom and hinge side trims
on the refrigerator compartment and freezer compartment
doors, making sure that the backer panel fits into the hinge
side trims.
I
I
I
MMMIIIIIIIIIMMMMIIIIIIIIIIIIMI
A. Panels
19