Battery Change - La Crosse Technology Wireless Weather Station Instruction Manual

Wireless 868 mhz weather station

Hide thumbs Also See for Wireless Weather Station:

Table of Contents

Enlarged version

BATTERY CHANGE:

It is recommended to replace the batteries in all units on an annual basis to ensure optimum accuracy of these

units.

Please participate in the preservation of the environment. Return used batteries to an

authorised depot.

SETTING UP:

WHEN ONE TRANSMITTER IS USED

First, insert the batteries in the transmitter (see "How to install and replace batteries in the Termo-hygro

outdoor transmitter" above).

Within 2 minutes of powering up the transmitter, insert the batteries in the Temperature Station (see "How to

install and replace batteries in the Weather Station" above). Once the batteries are in place, all

segments of the LCD will light up briefly and a short signal tone will sound. Following the indoor

temperature/humidity and the time as 0:00 will be displayed. If these information are not displayed on the

LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them. Once

the indoor data is displayed user may proceed to the next step.

After the batteries are inserted, the Weather station will start receiving data signal from the transmitter. The

outdoor temperature and humidity data should then be displayed on the Weather station. If this does not

happen after 2 minutes, the batteries will need to be removed from both units and reset from step 1.

In order to ensure sufficient 868 MHz transmission however, the distance between the Weather Station and

the transmitter should not be more than 100 meters (see notes on "Positioning" and "868 MHz

Reception").

Table of Contents