Mounting The Satellites; Specifications - Creative FourPointSurround FPS2000 Digital User Manual

Mounting The Satellites

To a flat surface:
To mount the satellites the side of a
monitor or other flat surface, use
the self-adhesive "hook and loop"
fastener squares.
To the wall:
To wall-mount the cubes on
structurally strong surfaces (a wall
stud or wood panelling), screw the
No. 10 screws into the material.
Allow their heads to protrude about
1/4 inch to fit into the keyhole slots
Hook and loop fastener mounting
on the back of each cube (as shown
below).
The plastic anchors supplied will
be needed to secure the screws in
most wall surfaces. If so, drill 1/4
inch holes in the wall, then tap the
anchors into the holes until they are
flush with the wall. Then screw the
screws into the anchors until they
protrude about 1/4 inch.
Be sure to apply the stick-on
rubber feet to the back of the satellite
cubes. This assures an acoustically
secure installation.
Keyhole slot mounting

Specifications

FPS2000 Digital's
Four-channel
Amplifier Specifications
Subwoofer: 25 watts RMS.
Satellite: 7 watts RMS per channel.
These specifications apply to a
FPS2000 Digital operating from a
15V DC power adapter.
15