Mounting The Satellites - Creative SoundWorks Digital FPS 2000 User Manual

Mounting the Satellites

To the monitor
To mount the satellites to the side of
a monitor, use two of the self-
adhesive "hook and loop" fasteners
per satellite (see diagram G).
G
To the wall
To wall-mount the satellites on
structurally strong surfaces (a wall
stud or wood paneling), screw the
M5X25mm screws into the material.
Allow their heads to protrude about
¼ inch to fit into the keyhole slots on
the back of each cube (see
diagram H).
The plastic anchors supplied will
be needed to secure the screw in
most wall surfaces. If so, drill ¼-inch
holes in the wall, then tap the
anchors into the holes until they are
flush with the wall. Then screw the
screws into the anchors until they
protrude about ¼ inch.
H
Be sure to apply the stick-on
rubber feet to the back of the satellite
cubes. This assures an acoustically
secure installation.
13