Attaching The Floor Stands - Creative FourPointSurround FPS2000 Digital User Manual

Attaching The Floor Stands

The rear satellites (with their
desktop stands attached) may be
installed in their floor stands.
1. One leg of each floor stand has
a full length slot, with short
notches opposite the slot at
each end. Insert a satellite
F
cable inside one of these legs by
feeding it down the length of the
full length slot. At each end, feed
the cable through the short notches
(see diagram G).
2. Insert the satellite end of the leg/
cable assembly into the middle
socket of the apex joint. Make sure
the satellite cable exits through the
short notch and not the full length
slot (see diagram F).
G
RE AR
RI GH T
3. Insert the two solid legs into the
outside sockets in the
apex joint.
4. Position the two "cut-away"
sections of the desktop stand
over the opening in the top of
the apex joint, as shown in
diagram F. Be sure to align the
face of the stand with the face
of the apex joint. Lower the
stand straight down into the
apex joint.
5. Holding the ends of the apex joint,
push on the front of the desktop stand
until it slips back into the slot in the
apex joint. Confirm a secure fit.
6. At the base of the rear leg, gently
pull on the satellite cable to
remove any unnecessary slack in
the cable.
7. Insert a rubber plug into the base
of each leg, taking care to feed the
cable out the short notch in the
rear leg (see diagram H).
H
9