GE ZISS480DXBSS Installation Instructions Manual page 17

Side by side refrigerators
Hide thumbs Also See for ZISS480DXBSS:
Table of Contents

Advertisement

Installation
Instructions
ISTEP12AI
(continued)
Custom
Handles
, If you are using custom handles, the handle must
be properly
secured to the overlay panel before sliding
the panel into the trim.
, The cabinet manufacturer
will supply the custom
handle and hardware.
, Discard the supplied handle.
Re/nst_J# a# original screws,
, Reinstall the handle side trim, using all 12 supplied
flat-head
screws, plus the 12 flat-head
screws
originally
installed
in the handle trim,
, Install e supplied end cap onto the top of the door,
using a Phillips head screwdriver
and the 2 screws
provided,
Hand-tighten
the screws into the end caps.
Do not overtighten;
damage
will occur.
, Clean the aluminum
trim with rubbing alcohol-
do not use alcohols
with oil or lanolin that will prevent
adhesion
of double-sided
tape.
, Slip the aluminum
cover trim behind the top end cap
to check the fit. The aluminum
cover trim has a recess
on each end which fits the end cap.
Cover Trim
Insert Aluminum
Trim/nto End
Cap.
ff
Top End Cap
f-it,s-Over the
Aluminum
Trim,
Secure Cap with
2 Screw.s,
, Remove the trim. Peel away a few inches
of the adhesive
backing.
IMPORTANT: The tape is very sticky and strong. Once
it adheres to a surface, it cannot be removed
without
damaging
both surfaces. Do not install
the trim before
the final wood panels are in place, Be sure to align
the trim carefully before removing the paper backing.
ISTEP 12A1 (continued)
, Carefully
place the aluminum
cover trim into top
end cap so that the recess is aligned with the cap.
Use the top to bottom
grooves
along the handle side
to align the cover trim accurately.
Pull the tape a few
inches at a time while pressing the trim against
the door. Press and hold approximately
10 seconds
before continuing
along the length of the door.
, Install another end cap at the bottom
of the door
to secure the cover trim. Use a stubby Phillips head
screwdriver
and the 2 screws provided.
NOTE: Make sure there are no gaps in the installation.
, Follow the same procedure
on the opposite
door.
17

Advertisement

Table of Contents
loading

Table of Contents