Epson EB-435W User Manual page 65

List of Functions
Sub-menu
Display You can make settings related to the projector's display.
Messages: When set to Off, the following items will not be
displayed.
Item names when the Source, Color Mode, or Aspect Ratio
is changed, messages when no signal is being input, and
warnings such as High Temp Warning.
Display Background
when no image signal is available to Black, Blue, or
Logo.
Startup Screen
when projection starts.
A/V Mute
remote control's [A/V Mute] button is pressed to Black,
Blue, or Logo.
*1 You can change the user's logo that is displayed as a
User's Logo
background during Display Background, A/V Mute, and so
on.
s "Saving a User's Logo"
Select from one of the following projection methods
Projection
depending on how the projector is installed.
Front, Front/Ceiling, Rear, and Rear/Ceiling
You can change the setting as follows by pressing down
the [A/V Mute] button on the remote control for about five
seconds.
FrontWFront/Ceiling
RearWRear/Ceiling
s "Installation Methods"
Function
*1 : You can set the screen status for
*1 : Set to On to display the User's Logo
*1 : You can set the screen displayed when the
p.48
p.17
Sub-menu
Operation Direct Power On: Set to On to turn on the projector
simply by plugging it in.
When the power cable is plugged in, note that the projector
turns on automatically in cases such as a power outage
being restored.
Sleep Mode: When this is set to On, the power is turned
off automatically when no image signal is input and no
operation is performed within a certain amount of time.
Sleep Mode Timer: When Sleep Mode is set to On, you
can set the time before the projector automatically turns off
within a range of 1 to 30 minutes.
High Altitude Mode: Set this to On when using the
projector at an altitude of 1500 m or above.
Audio Input: When set to Auto, audio for the image
currently being projected is output.If anything other than
Auto is selected, audio for the selected audio input port is
output.When the input source is HDMI, USB Display, or
LAN, the audio for the image currently being projected is
output regardless of the Audio Input setting.
If you set Communication On, you can perform the
Standby Mode
following operations even if the projector is in standby
mode.
• Monitoring and controlling the projector over the
network.
s "Monitoring and Controlling"
• Outputting analog RGB signals from the Computer1 port
to an external monitor.
• Outputting audio from the microphone to the projector's
speaker.
(Only when the Standby Microphone is set to On.)
s "Connecting Image Sources"
Standby Micro- (This item is settable only when Standby Mode set to
phone Communication On.)
When set to On, you can output audio from the
microphone from the projector's speaker even if the
projector is in standby mode.
65
Function
p.108
p.19