Removing A Spark Module & Power Cord - Whirlpool KGCT055 Owner's Manual

REMOVING A SPARK MODULE & POWER CORD
WARNING
Electrical Shock Hazard
Disconnect from electrical and gas supplies
before servicing unit.
Failure to do so could result in death, elec-
trical shock, or explosion.
CAUTION: When you work on the cooktop, be
careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
1. Turn off the gas supply and electrical
power to the cooktop.
2. Remove the maintop from the mounting
box (refer to page 4-2 for the procedure).
Refer to Figure 4-3 for the following steps.
3. To remove the spark module, discon-
nect the wires from the terminals and
remove the mountng screw(s). NOTE: Both
types of spark module are shown in the
illustration. Use whichever one matches
the cooktop you are servicing.
Brown Wires
(to Spark Ignitors)
Spark Module
For 36" & 45"
Model Cooktops
Hex-Head
Screw (3)
Power
Cord
White Wire
(from Ignitor Switch)
Figure 4-3
4. To remove the power cord:
a) Disconnect the lead from the spark
module terminal, and from the ignitor
switch wire connector.
b) Remove the screw from the ground wire
eyelet.
c) Use a pair of pliers and squeeze the
strain relief sections together while
pressing down, and remove the strain
relief and power cord from the burner
box.
Brown Wires
(to Spark Ignitors)
Spark Module
For 30" Model
Cooktops
White Wire
(from Ignitor Switch)
Yellow Wires
(to Spark Ignitors)
Green
Ground Wire
4-4
Yellow Wires
(to Spark Ignitors)
Hex-Head Screw
Ignitor Switch
Wire Connector
Strain
Relief
Black Wire
(from Ignitor Switch)
Ground Wire