Table of Contents
Advertisement
05651106 22/11/00 8:30 pm Page 6
Remove the machine from the
packaging - close to where it will finally
be positioned - and proceed as follows:
On the back of the machine
1) Remove the central screw A and
side screws B and pull out the transit
bracket C complete with the red spacer.
2) Tilt the machine forward and remove
the polystyrene spacers .
3
Cover the central hole using the cap
enclosed in the instructions bag.
4) Adjust the two feet at the front to
level the machine.
5) Tilt the machine forward and locate the
base panel by
backing from the adhesive tape,
the base panel in the front of the machine
offer the base panel up to the base of the
washing machine and locate the two clips.
Installation & Testing
removing the paper
locate
6
Hide quick links:
Advertisement
Table of Contents
